public void BeginAndEndMLine()
{
MockGCodeAccumulator mockGCA = new MockGCodeAccumulator();
GCodeBuilder gcb = new GCodeBuilder(mockGCA);
gcb.BeginMLine(1, "comment");
Assert.IsTrue(mockGCA.Lines.Count == 0);
gcb.EndLine();
Assert.IsTrue(mockGCA.Lines.Count == 1);
Assert.AreEqual("comment", mockGCA.Lines[0].Comment);
Assert.AreEqual(LineType.MCode, mockGCA.Lines[0].Type);
Assert.AreEqual(0, mockGCA.Lines[0].LineNumber);
}
protected virtual void HeaderCustomF(RepRapAssembler.HeaderState state, GCodeBuilder Builder)
{
if (state == RepRapAssembler.HeaderState.AfterComments)
{
if (ModelEnum == Prusa.Models.i3_MK3)
{
Builder.BeginMLine(201)
.AppendI("X", 1000).AppendI("Y", 1000).AppendI("Z", 200).AppendI("E", 5000)
.AppendComment("Set maximum accelleration in mm/sec^2");
Builder.BeginMLine(203)
.AppendI("X", 200).AppendI("Y", 200).AppendI("Z", 12).AppendI("E", 120)
.AppendComment("Set maximum feedrates in mm/sec");
Builder.BeginMLine(204)
.AppendI("S", 1250).AppendI("T", 1250)
.AppendComment("Set acceleration for moves (S) and retract (T)");
Builder.BeginMLine(205)
.AppendF("X", 10).AppendF("Y", 10).AppendF("Z", 0.4).AppendF("E", 2.5)
.AppendComment("Set jerk limits in mm/sec");
Builder.BeginMLine(205)
.AppendI("S", 0).AppendI("T", 0)
.AppendComment("Set minimum extrude and travel feed rate in mm/sec");
}
}
}