public MetaEventMultiLineStage AddSubstage(MetaEventStage substage)
{
if (!m_SubStages.ContainsKey(substage.Name))
m_SubStages.Add(substage.Name, substage);
else
{
foreach (EventState state in substage.EventStates)
m_SubStages[substage.Name].EventStates.Add(state);
}
return this;
}
public MetaEventMultiLineStage AddSubstage(MetaEventStage substage)
{
if (!m_SubStages.ContainsKey(substage.Name))
{
m_SubStages.Add(substage.Name, substage);
}
else
{
foreach (EventState state in substage.EventStates)
{
m_SubStages[substage.Name].EventStates.Add(state);
}
}
return(this);
}
public MetaEvent AddStage(MetaEventStage stage)
{
Stages.Add(stage);
return(this);
}
public virtual int GetStageId(HashSet <EventState> eventStates, int prevStageId = -1)
{
int stageId = -1;
int blockedStageId = -1;
IEnumerator <MetaEventStage> itr = Stages.GetEnumerator();
for (int i = 0; itr.MoveNext(); i++)
{
if (itr.Current.IsActive(eventStates))
{
if (itr.Current.Type == MetaEventStage.StageType.Blocking)
{
blockedStageId = i;
}
else
{
stageId = i;
break;
}
}
}
/* Recovery states need special treatment.
* If our current stage is recovery and consists entirely of warmups, we need to make sure that the
* previous stage was a recovery and was successful to ensure that we were actually in recovery.
*/
if (stageId >= 0 && itr.Current.Type == MetaEventStage.StageType.Recovery &&
itr.Current.EventStates.Where(es => es.State != EventStateType.Warmup).Count() == 0)
{
if (!(prevStageId >= 0 && itr.Current.Type == MetaEventStage.StageType.Recovery &&
itr.Current.IsSuccessful(eventStates)))
{
stageId = -1;
}
}
/* The following logic checks if the previous stage succeeded and therefore the stage is active.
* This is to deal with meta events that don't immediately put the next stage events into Perparation
* or Active status. This will only execute if we have yet to find a stage, the previous stage is
* supplied, and the previous stage is not the last stage. If all of these conditions are met, set the
* stage to the prevStageId + 1 if all of the previous stage's events are at status Success.
*/
if (stageId < 0 && prevStageId >= 0 && prevStageId < Stages.Count - 1)
{
MetaEventStage prevStage = Stages.ElementAt(prevStageId);
if (!prevStage.IsEndStage && prevStage.IsSuccessful(eventStates))
{
stageId = prevStageId;
}
}
/* Lastly, if we still don't have a stage id, but we have a blocked stage id, then we use the blocked stage.
* We do this because blocked events aren't really part of the meta, so we don't want them showing up most of
* the time. Thus we always keep the non-blocked stage if it exists.
*/
if (stageId < 0 && blockedStageId >= 0)
{
stageId = blockedStageId;
}
return(stageId);
}
public MetaEvent AddStage(MetaEventStage stage)
{
Stages.Add(stage);
return this;
}
