protected void HeaderCustomF(RepRapAssembler.HeaderState state, GCodeBuilder Builder)
{
if (state == RepRapAssembler.HeaderState.BeforePrime)
{
if (EnableAutoBedLevel)
{
Builder.BeginGLine(29, "auto-level bed");
}
}
}
private static void HeaderCustomF(
IPrintProfileFFF settings, RepRapAssembler.HeaderState state, GCodeBuilder builder)
{
if (state == RepRapAssembler.HeaderState.BeforePrime)
{
if (settings.Machine.HasAutoBedLeveling && settings.Machine.EnableAutoBedLeveling)
{
builder.BeginGLine(29, "auto-level bed");
}
}
}
private static void HeaderCustomF(RepRapAssembler.HeaderState state, GCodeBuilder Builder)
{
if (state == RepRapAssembler.HeaderState.AfterComments)
{
Builder.BeginMLine(201)
.AppendI("X", 1000).AppendI("Y", 1000).AppendI("Z", 200).AppendI("E", 5000)
.AppendComment("Set maximum accelleration in mm/sec^2");
Builder.BeginMLine(203)
.AppendI("X", 200).AppendI("Y", 200).AppendI("Z", 12).AppendI("E", 120)
.AppendComment("Set maximum feedrates in mm/sec");
Builder.BeginMLine(204)
.AppendI("S", 1250).AppendI("T", 1250)
.AppendComment("Set acceleration for moves (S) and retract (T)");
Builder.BeginMLine(205)
.AppendF("X", 10).AppendF("Y", 10).AppendF("Z", 0.4).AppendF("E", 2.5)
.AppendComment("Set jerk limits in mm/sec");
Builder.BeginMLine(205)
.AppendI("S", 0).AppendI("T", 0)
.AppendComment("Set minimum extrude and travel feed rate in mm/sec");
}
}
