public Boolean Start_Single_TTA()
{
//1.Strom einschalten
MyRack.MeasCurrent_on();
//2.Spannung bei Imeas und RaumTemperatur messen
V_f_at_Imeas_Troom = MyDAQ.Get_Constant_Voltage(this, this.GUI);
//3.Strom aus
MyRack.MeasCurrent_off();
//Eigentliche TTA messung
return(MyDAQ.Measure_TTA_Several_Cycles(this, this.GUI));
}
//********************************************************************************************************************
// globale Funktionen
//********************************************************************************************************************
/// <summary>
/// TTA measurment without XYZ (but with repetation cycles)
/// </summary>
/// <returns>Flag of status</returns>
public bool Start_Single_TTA()
{
//Status-Bar initialisieren
GUI.StatusBar_TTA_Single(0, (int)MyRack.Cycles);
//DAQ-System anpassen
if (!MyDAQ.TTA_set_Device(MyRack.Time_Heat, MyRack.Time_Meas))
{
return(false);
}
if (!MyDAQ.TTA_set_Trigger(MyRack.Gain, MyRack.U_offset))
{
return(false);
}
//Definiere Feld für Raw-Daten
Binary_Raw_Files = new short[MyRack.Cycles, MyDAQ.Samples];
//Speicher reservieren
MyDAQ.TTA_reserve_Storage(Binary_Raw_Files);
//Loop für Wiederholungs-Zyklen
for (int repetation_nr = 0; repetation_nr < MyRack.Cycles; repetation_nr++)
{
//Bei bedarf abbrechen
if (GUI.myBackroundWorker.CancellationPending)
{
//Falls abbruch --> Speicher lösen
MyDAQ.TTA_free_Storage(Binary_Raw_Files);
return(false);
}
//DAQ scharf stellen
if (!MyDAQ.TTA_wait_for_Trigger())
{
return(false);
}
//Puls starten (bei NI mit Warten sonst ohne)
MyRack.SinglePuls_withoutDelay();
//Daten abholen
if (!MyDAQ.TTA_Collect_Data(Binary_Raw_Files, repetation_nr))
{
return(false);
}
//Daten prüfen
//????????????????????????????????????????
//Daten in Raw plotten
GUI.Add_Series_to_RAW(this, repetation_nr);
//Statusbar anpassen
GUI.StatusBar_TTA_Single(repetation_nr + 1, (int)MyRack.Cycles);
}
//DatenSatz auswerten
Convert_Data();
//Speicher lösen
MyDAQ.TTA_free_Storage(Binary_Raw_Files);
return(true);
}
