//NETLIST_START(konami1x)
void netlist_konami1x(netlist.nlparse_t setup)
{
netlist.helper h = new netlist.helper();
h.NETLIST_START(setup);
h.SOLVER("Solver", 48000);
h.ANALOG_INPUT("VP5", 5);
h.ANALOG_INPUT("VM5", -5);
h.LOCAL_SOURCE("filter", netlist_filter);
h.LOCAL_SOURCE("amp", netlist_amp);
h.LOCAL_SOURCE("AY1", netlist_AY1);
h.LOCAL_SOURCE("AY2", netlist_AY2);
h.INCLUDE("AY1");
h.NET_C("FCHA1.O", "FCHB1.O", "FCHC1.O");
h.SUBMODEL("amp", "AMP");
h.NET_C("VP5", "AMP.VP");
h.NET_C("GND", "AMP.GND");
h.NET_C("VM5", "AMP.VM");
h.NET_C("FCHA1.O", "AMP.OPAMP");
h.ALIAS("OUT", "AMP.OUT");
h.NETLIST_END();
}
//NETLIST_START(gunfight)
public static void netlist_gunfight(netlist.nlparse_t setup)
{
netlist.helper h = new netlist.helper();
h.NETLIST_START(setup);
h.SOLVER("Solver", 48000);
h.PARAM("Solver.SORT_TYPE", "ASCENDING");
// For this netlist, ASCENDING turns out to be slightly faster than
// the default sort type of PREFER_IDENTITY_TOP_LEFT, but the
// difference when using static solvers is very small.
h.LOCAL_SOURCE("gunfight_schematics", netlist_gunfight_schematics);
h.INCLUDE("gunfight_schematics");
// The amplifying transistors all get 16-volt power. The raw AC power
// input from the main power supply to the game logic board is 16.5
// volts, but this is rectified and regulated to about 16 volts via
// TIP-31 power transistor Q301 and BZX61-C16 16-volt Zener diode
// D304.
h.ANALOG_INPUT("I_V16", 16); // 16-volt power for sound amplifiers
h.ANALOG_INPUT("I_V5", 5); // 5-volt power for logic input devices
h.LOGIC_INPUT("I_LEFT_SHOT", 0, "74XX");
h.LOGIC_INPUT("I_RIGHT_SHOT", 0, "74XX");
h.LOGIC_INPUT("I_LEFT_HIT", 0, "74XX");
h.LOGIC_INPUT("I_RIGHT_HIT", 0, "74XX");
// Power and ground connections for logic input devices:
h.NET_C("I_V5.Q",
"I_LEFT_SHOT.VCC", "I_RIGHT_SHOT.VCC",
"I_LEFT_HIT.VCC", "I_RIGHT_HIT.VCC");
h.NET_C("GND",
"I_LEFT_SHOT.GND", "I_RIGHT_SHOT.GND",
"I_LEFT_HIT.GND", "I_RIGHT_HIT.GND");
h.ALIAS("IN_LS", "I_LEFT_SHOT.Q");
h.ALIAS("IN_RS", "I_RIGHT_SHOT.Q");
h.ALIAS("IN_LH", "I_LEFT_HIT.Q");
h.ALIAS("IN_RH", "I_RIGHT_HIT.Q");
#if USE_FRONTIERS
// These frontiers keep the mostly independant halves of the circuit
// (left channel and right channel) from affecting each other and the
// noise generator, which speeds up processing substantially while
// making no audible change in the output. These seem to be the only
// frontiers which improve performance; I haven't been able to find
// any additional beneficial ones from examining the circuit and
// experimenting.
h.OPTIMIZE_FRONTIER("C303.1", RES_M(1), 50);
h.OPTIMIZE_FRONTIER("C306.1", RES_M(1), 50);
h.OPTIMIZE_FRONTIER("C304.1", RES_M(1), 50);
h.OPTIMIZE_FRONTIER("C305.1", RES_M(1), 50);
#endif
h.NETLIST_END();
}
//static NETLIST_START(1942)
void netlist_1942(netlist.nlparse_t setup)
{
netlist.helper h = new netlist.helper();
h.NETLIST_START(setup);
/* Standard stuff */
h.SOLVER("Solver", 48000);
h.ANALOG_INPUT("V5", 5);
/* AY 8910 internal resistors */
h.RES("R_AY1_1", 1000);
h.RES("R_AY1_2", 1000);
h.RES("R_AY1_3", 1000);
h.RES("R_AY2_1", 1000);
h.RES("R_AY2_2", 1000);
h.RES("R_AY2_3", 1000);
h.RES("R2", 220000);
h.RES("R3", 220000);
h.RES("R4", 220000);
h.RES("R5", 220000);
h.RES("R6", 220000);
h.RES("R7", 220000);
h.RES("R11", 10000);
h.RES("R12", 10000);
h.RES("R13", 10000);
h.RES("R14", 10000);
h.RES("R15", 10000);
h.RES("R16", 10000);
h.CAP("CC7", 10e-6);
h.CAP("CC8", 10e-6);
h.CAP("CC9", 10e-6);
h.CAP("CC10", 10e-6);
h.CAP("CC11", 10e-6);
h.CAP("CC12", 10e-6);
h.NET_C("V5", "R_AY2_3.1", "R_AY2_2.1", "R_AY2_1.1", "R_AY1_3.1", "R_AY1_2.1", "R_AY1_1.1");
h.NET_C("GND", "R13.2", "R15.2", "R11.2", "R12.2", "R14.2", "R16.2");
//NLFILT(R_AY2_3, R13, CC7, R2)
h.NET_C("R_AY2_3.2", "R13.1");
h.NET_C("R13.1", "CC7.1");
h.NET_C("CC7.2", "R2.1");
//NLFILT(R_AY2_2, R15, CC8, R3)
h.NET_C("R_AY2_2.2", "R15.1");
h.NET_C("R15.1", "CC8.1");
h.NET_C("CC8.2", "R3.1");
//NLFILT(R_AY2_1, R11, CC9, R4)
h.NET_C("R_AY2_1.2", "R11.1");
h.NET_C("R11.1", "CC9.1");
h.NET_C("CC9.2", "R4.1");
//NLFILT(R_AY1_3, R12, CC10, R5)
h.NET_C("R_AY1_3.2", "R12.1");
h.NET_C("R12.1", "CC10.1");
h.NET_C("CC10.2", "R5.1");
//NLFILT(R_AY1_2, R14, CC11, R6)
h.NET_C("R_AY1_2.2", "R14.1");
h.NET_C("R14.1", "CC11.1");
h.NET_C("CC11.2", "R6.1");
//NLFILT(R_AY1_1, R16, CC12, R7)
h.NET_C("R_AY1_1.2", "R16.1");
h.NET_C("R16.1", "CC12.1");
h.NET_C("CC12.2", "R7.1");
h.POT("VR", 2000);
h.NET_C("VR.3", "GND");
h.NET_C("R2.2", "VR.1");
h.NET_C("R3.2", "VR.1");
h.NET_C("R4.2", "VR.1");
h.NET_C("R5.2", "VR.1");
h.NET_C("R6.2", "VR.1");
h.NET_C("R7.2", "VR.1");
h.CAP("CC6", 10e-6);
h.RES("R1", 100000);
h.NET_C("CC6.1", "VR.2");
h.NET_C("CC6.2", "R1.1");
h.CAP("CC3", 220e-6);
h.NET_C("R1.2", "CC3.1");
h.NET_C("CC3.2", "GND");
h.NETLIST_END();
}