internal void Connect(IModbusRtuSerialPort serialPort)
{
if (this.Parity == Parity.None && this.StopBits != StopBits.Two)
{
throw new InvalidOperationException(ErrorMessage.Modbus_NoParityRequiresTwoStopBits);
}
_frameBuffer = new ModbusFrameBuffer(256);
_serialPort?.Close();
_serialPort = serialPort;
_serialPort.Open();
}
internal void Connect(IModbusRtuSerialPort serialPort, ModbusEndianness endianness)
{
if (this.Parity == Parity.None && this.StopBits != StopBits.Two)
{
throw new InvalidOperationException(ErrorMessage.Modbus_NoParityRequiresTwoStopBits);
}
base.SwapBytes = BitConverter.IsLittleEndian && endianness == ModbusEndianness.BigEndian ||
!BitConverter.IsLittleEndian && endianness == ModbusEndianness.LittleEndian;
_frameBuffer = new ModbusFrameBuffer(256);
_serialPort?.Close();
_serialPort = serialPort;
_serialPort.Open();
}
internal void Connect(IModbusRtuSerialPort serialPort, ModbusEndianness endianness)
{
/* According to the spec (https://www.modbus.org/docs/Modbus_over_serial_line_V1_02.pdf),
* section 2.5.1 RTU Transmission Mode: "... the use of no parity requires 2 stop bits."
* Remove this check to improve compatibility (#56).
*/
//if (this.Parity == Parity.None && this.StopBits != StopBits.Two)
// throw new InvalidOperationException(ErrorMessage.Modbus_NoParityRequiresTwoStopBits);
base.SwapBytes = BitConverter.IsLittleEndian && endianness == ModbusEndianness.BigEndian ||
!BitConverter.IsLittleEndian && endianness == ModbusEndianness.LittleEndian;
_frameBuffer = new ModbusFrameBuffer(256);
_serialPort?.Close();
_serialPort = serialPort;
_serialPort.Open();
}
/// <summary>
/// Connect to the specified <paramref name="remoteEndpoint"/>.
/// </summary>
/// <param name="remoteEndpoint">The IP address and port of the end unit.</param>
/// <param name="endianness">Specifies the endianness of the data exchanged with the Modbus server.</param>
public void Connect(IPEndPoint remoteEndpoint, ModbusEndianness endianness)
{
base.SwapBytes = BitConverter.IsLittleEndian && endianness == ModbusEndianness.BigEndian ||
!BitConverter.IsLittleEndian && endianness == ModbusEndianness.LittleEndian;
_frameBuffer = new ModbusFrameBuffer(260);
_tcpClient?.Close();
_tcpClient = new TcpClient();
if (!_tcpClient.ConnectAsync(remoteEndpoint.Address, remoteEndpoint.Port).Wait(this.ConnectTimeout))
{
throw new Exception(ErrorMessage.ModbusClient_TcpConnectTimeout);
}
_networkStream = _tcpClient.GetStream();
_networkStream.ReadTimeout = this.ReadTimeout;
_networkStream.WriteTimeout = this.WriteTimeout;
}
