public void SendtoAutoCAD(PlanSwift.Item AItem) { PlanSwift.ISection CurrentSection; PlanSwift.INode CurrentNode; int ItemDigiType, SectionIndex, NodeIndex; double Xscale, Yscale; float nx, ny; object StartNode, EndNode; if (AItem.DigiType != 3) { ItemDigiType = AItem.DigiType; switch (ItemDigiType) { // IF Digitizer type is "Area" do something case 0: for (SectionIndex = 0; SectionIndex <= AItem.Sections.Count - 1; SectionIndex++) { CurrentSection = AItem.Sections[SectionIndex]; StartNode = CurrentSection.Nodes[0].Point; EndNode = CurrentSection.Nodes[CurrentSection.Nodes.Count - 1].Point; double[] SP = new double[((CurrentSection.Nodes.Count + 1) * 2)]; Xscale = CurrentSection.Page().ScaleX; Yscale = CurrentSection.Page().ScaleY; //Loop Though all nodes in current section for (NodeIndex = 0; NodeIndex <= CurrentSection.Nodes.Count - 1; NodeIndex++) { CurrentNode = CurrentSection.Nodes[NodeIndex]; nx = CurrentNode.x; ny = -CurrentNode.y; SP[NodeIndex * 2] = (nx / Xscale) * 12; SP[NodeIndex * 2 + 1] = (ny / Yscale) * 12; } //Close lines of the area SP[SP.Length - 2] = (CurrentSection.Nodes[0].x / Xscale) * 12; SP[SP.Length - 1] = (-CurrentSection.Nodes[0].y / Yscale) * 12; AuDocument.ModelSpace.AddLightWeightPolyline(SP); } break; } } }