//取得機臺狀態
private void getCNCInfo()
{
string eqpStatus = "";
short ret = iRemoting.SKY_conn_status(_Pwd, ref _SkyConn_status);
if (ret == 0)
{
switch (_SkyConn_status.Status[0])
{
case 0:
eqpStatus = "OFF";
break;
case 1:
eqpStatus = "RUN";
break;
case 2:
eqpStatus = "IDLE";
break;
case 3:
eqpStatus = "Alarm";
break;
}
}
currentStatus = eqpStatus;
//取得程式名稱
ret = iRemoting.SKY_nc_filename(_Pwd, ref _SkyNc_filename);
if (ret == 0)
{
currentProgName = _SkyNc_filename.MainProg[0];
}
//取得程式內容
ret = iRemoting.GET_nc_current_block(_Pwd, ref _nc_current_block);
if (ret == 0)
{
currentProg = "";
for (int i = 0; i <= _nc_current_block.Block.Length - 1; i++)
{
currentProg += _nc_current_block.Block[i] + "\r\n";
}
}
//取得循環時間
ret = iRemoting.GET_time(_Pwd, ref _time);
if (ret == 0)
{
cycleTime = _time.Cycle;
}
//取得刀號
ret = iRemoting.GET_othercode(_Pwd, ref _othercode);
if (ret == 0)
{
currentTCode = _othercode.TCode.ToString();
}
}
private void S1_Tick(object sender, EventArgs e)
{
//主程
_SkyNc_filename.RetType = -1;
ret = iRemoting.SKY_nc_filename(_Pwd, ref _SkyNc_filename);
if (ret == 0)
{
txtProg_F.Text = _SkyNc_filename.MainProg[0];
}
//狀態及模式
ret = iRemoting.GET_status(_Pwd, ref _status);
if (ret == 0)
{
txtStatus_F.Text = _status.Status;
txtMode_F.Text = _status.Mode;
}
ret = iRemoting.GET_spindle_speed(_Pwd, ref _spindle_speed);
if (ret == 0)
{
label17.Text = _spindle_speed.SpSpeed.ToString();
}
}
