// Note: A constructor summary is auto-generated by the doc builder.
/// <summary></summary>
/// <param name="socket">The socket for the interrupt input interface.</param>
/// <param name="pin">The pin used by the interrupt input interface.</param>
/// <param name="glitchFilterMode">
/// A value from the <see cref="GlitchFilterMode"/> enumeration that specifies
/// whether to enable the glitch filter on this interrupt input interface.
/// </param>
/// <param name="resistorMode">
/// A value from the <see cref="ResistorMode"/> enumeration that establishes a default state for the interrupt input interface. N.B. .NET Gadgeteer mainboards are only required to support ResistorMode.PullUp on interruptable GPIOs and are never required to support ResistorMode.PullDown; consider putting the resistor on the module itself.
/// </param>
/// <param name="interruptMode">
/// A value from the <see cref="InterruptMode"/> enumeration that establishes the requisite conditions
/// for the interface port to generate an interrupt.
/// </param>
/// <param name="module">The module using this interrupt input interface, which can be null if unspecified.</param>
public InterruptInput(Socket socket, Socket.Pin pin, GlitchFilterMode glitchFilterMode, ResistorMode resistorMode, InterruptMode interruptMode, Module module)
{
Cpu.Pin reservedPin = socket.ReservePin(pin, module);
// native implementation is preferred to an indirected one
if (reservedPin == Cpu.Pin.GPIO_NONE && socket.InterruptIndirector != null)
{
Interface = socket.InterruptIndirector(socket, pin, glitchFilterMode, resistorMode, interruptMode, module);
}
else
{
Interface = new NativeInterruptInput(socket, pin, glitchFilterMode, resistorMode, interruptMode, module, reservedPin);
}
}
private void OnInterfaceInterrupt(Socket.SocketInterfaces.InterruptInput sender, bool value)
{
OnInterruptEvent(this, value);
}
// Note: A constructor summary is auto-generated by the doc builder.
/// <summary></summary>
/// <param name="socket">The socket for the interrupt input interface.</param>
/// <param name="pin">The pin used by the interrupt input interface.</param>
/// <param name="glitchFilterMode">
/// A value from the <see cref="GlitchFilterMode"/> enumeration that specifies
/// whether to enable the glitch filter on this interrupt input interface.
/// </param>
/// <param name="resistorMode">
/// A value from the <see cref="ResistorMode"/> enumeration that establishes a default state for the interrupt input interface. N.B. .NET Gadgeteer mainboards are only required to support ResistorMode.PullUp on interruptable GPIOs and are never required to support ResistorMode.PullDown; consider putting the resistor on the module itself.
/// </param>
/// <param name="interruptMode">
/// A value from the <see cref="InterruptMode"/> enumeration that establishes the requisite conditions
/// for the interface port to generate an interrupt.
/// </param>
/// <param name="module">The module using this interrupt input interface, which can be null if unspecified.</param>
public InterruptInput(Socket socket, Socket.Pin pin, GlitchFilterMode glitchFilterMode, ResistorMode resistorMode, InterruptMode interruptMode, Module module)
{
Cpu.Pin reservedPin = socket.ReservePin(pin, module);
// native implementation is preferred to an indirected one
if (reservedPin == Cpu.Pin.GPIO_NONE && socket.InterruptIndirector != null)
Interface = socket.InterruptIndirector(socket, pin, glitchFilterMode, resistorMode, interruptMode, module);
else
Interface = new NativeInterruptInput(socket, pin, glitchFilterMode, resistorMode, interruptMode, module, reservedPin);
}
