public static void Main(string[] args)
{
// NOTE: To disable debug output uncomment the following two lines
//LogManager.Configuration.LoggingRules.RemoveAt(0);
//LogManager.Configuration.Reload();
serialPort = new SerialPortInput();
serialPort.ConnectionStatusChanged += SerialPort_ConnectionStatusChanged;
serialPort.MessageReceived += SerialPort_MessageReceived;
while (true)
{
Console.WriteLine("\nPlease enter serial to open (eg. \"COM7\" or \"/dev/ttyUSB0\" without double quotes),");
Console.WriteLine("or enter \"QUIT\" to exit.\n");
Console.Write("Port [{0}]: ", defaultPort);
string port = Console.ReadLine();
if (String.IsNullOrWhiteSpace(port))
port = defaultPort;
else
defaultPort = port;
// exit if the user enters "quit"
if (port.Trim().ToLower().Equals("quit"))
break;
serialPort.SetPort(port, 115200);
serialPort.Connect();
Console.WriteLine("Waiting for serial port connection on {0}.", port);
while (!serialPort.IsConnected)
{
Console.Write(".");
Thread.Sleep(1000);
}
// This is a test message (ZWave protocol message for getting the nodes stored in the Controller)
var testMessage = new byte[] { 0x01, 0x03, 0x00, 0x02, 0xFE };
// Try sending some data if connected
if (serialPort.IsConnected)
{
Console.WriteLine("\nConnected! Sending test message 5 times.");
for (int s = 0; s < 5; s++)
{
Thread.Sleep(1000);
Console.WriteLine("\nSEND [{0}]", (s + 1));
serialPort.SendMessage(testMessage);
}
}
Console.WriteLine("\nTest sequence completed, now disconnecting.");
serialPort.Disconnect();
}
}
