// TESTING
public CompBallCutter(double diam2, double clength)
{
MillingCutter shaft = new BallCutter(diam2, clength);
addCutter(shaft, diam2 / 2.0, clength, 0.0);
length = clength;
}
} // dummy, required(?) by python wrapper
/// create ballconecutter
public BallConeCutter(double diam1, double diam2, double angle)
{
MillingCutter c1 = new BallCutter(diam1, 1); // at offset zero
MillingCutter c2 = new ConeCutter(diam2, angle);
MillingCutter shaft = new CylCutter(diam2, 20); // FIXME: length
double radius1 = diam1 / 2.0;
double radius2 = diam2 / 2.0;
double rcontact = radius1 * Math.Cos(angle);
double height1 = radius1 - Math.Sqrt(ocl.GlobalMembers.square(radius1) - ocl.GlobalMembers.square(rcontact));
double cone_offset = -((rcontact) / Math.Tan(angle) - height1);
double height2 = radius2 / Math.Tan(angle) + cone_offset;
double shaft_offset = height2;
// cutter, radivec, heightvec, zoffset
addCutter(c1, rcontact, height1, 0.0);
addCutter(c2, diam2 / 2.0, height2, cone_offset);
addCutter(shaft, diam2 / 2.0, height2 + 20, shaft_offset);
length = 30;
}