Ejemplo n.º 1
0
        public MCP23017(byte address = 0x20)
        {
            i2cDevice = new NetduinoI2CDevice(address);

            // set the defaults
            i2cDevice.WriteRegister((byte)Command.MCP23017_IODIRA, 0xff);
            i2cDevice.WriteRegister((byte)Command.MCP23017_IODIRB, 0xff);
        }
        public MCP23017(byte address = 0x20)
        {
            i2cDevice = new NetduinoI2CDevice(address);

            // set the defaults
            i2cDevice.WriteRegister((byte)Command.MCP23017_IODIRA, 0xff);
            i2cDevice.WriteRegister((byte)Command.MCP23017_IODIRB, 0xff);

            //The below were added in order to read the interrupt from the chip.
            //i2cDevice configuration register
            // mirror interrupts, disable sequential mode
            i2cDevice.WriteRegister((byte)Command.MCP23017_IOCONA, 0x60); // 0b01100000 (binary) = ox60 (hexadecimal)
            // enable pull-up on switches
            i2cDevice.WriteRegister((byte)Command.MCP23017_GPPUA, 0xff); // pull-up resistor for switch - both ports
            // invert polarity
            i2cDevice.WriteRegister((byte)Command.MCP23017_IPOLA, 0xff); // invert polarity of signal - both ports
            // enable all interrupts. This one is what needs to be enabled for the data to flow to the pin...
            i2cDevice.WriteRegister((byte)Command.MCP23017_GPINTENA, 0xff);
            //i2cDevice.WriteRegister((byte)0x12, 0xff);
        }