public frm8536Count()
{
// This call is required by the Windows Form Designer.
InitializeComponent();
// Initiate error handling
// activating error handling will trap errors like
// bad channel numbers and non-configured conditions.
// Parameters:
// MccDaq.ErrorReporting.PrintAll :all warnings and errors encountered will be printed
// MccDaq.ErrorHandling.StopAll :if an error is encountered, the program will stop
MccDaq.ErrorInfo ULStat = MccDaq.MccService.ErrHandling(MccDaq.ErrorReporting.PrintAll, MccDaq.ErrorHandling.StopAll);
// Create a new MccBoard object for Board 0
DaqBoard = new MccDaq.MccBoard(0);
// Init the counter for desired operation
// Parameters:
// ChipNum :the chip to be setup
// Ctr1Output :how the counter output is used
short ChipNum = 1;
MccDaq.CtrlOutput Ctr1Output = MccDaq.CtrlOutput.NotLinked;
ULStat = DaqBoard.C8536Init(ChipNum, Ctr1Output);
// Configure the counter for desired operation
// Parameters:
// CounterNum :which counter
// OutputControl :which counter output signal is used
// RecycleMode :reload at 0 ?
// TrigType :trigger type
CounterNum = 1;
MccDaq.C8536OutputControl OutputControl = MccDaq.C8536OutputControl.ToggleOnTc;
MccDaq.RecycleMode RecycleMode = MccDaq.RecycleMode.Recycle;
MccDaq.C8536TriggerType TrigType = MccDaq.C8536TriggerType.HWStartTrig;
ULStat = DaqBoard.C8536Config(CounterNum, OutputControl, RecycleMode, TrigType);
}
private void frm8536Count_Load(object sender, EventArgs e)
{
InitUL();
NumCtrs = CtrProps.FindCountersOfType(DaqBoard, CounterType, out CounterNum);
if (NumCtrs == 0)
{
lblNoteFreqIn.Text = "Board " + DaqBoard.BoardNum.ToString() +
" has no 8536 counters.";
cmdStart.Enabled = false;
}
else
{
// Init the counter for desired operation
// Parameters:
// ChipNum :the chip to be setup
// Ctr1Output :how the counter output is used
short ChipNum = 1;
MccDaq.CtrlOutput Ctr1Output = MccDaq.CtrlOutput.NotLinked;
MccDaq.ErrorInfo ULStat = DaqBoard.C8536Init(ChipNum, Ctr1Output);
// Configure the counter for desired operation
// Parameters:
// CounterNum :which counter
// OutputControl :which counter output signal is used
// RecycleMode :reload at 0 ?
// TrigType :trigger type
CounterNum = 1;
MccDaq.C8536OutputControl OutputControl = MccDaq.C8536OutputControl.ToggleOnTc;
MccDaq.RecycleMode RecycleMode = MccDaq.RecycleMode.Recycle;
MccDaq.C8536TriggerType TrigType = MccDaq.C8536TriggerType.HWStartTrig;
ULStat = DaqBoard.C8536Config(CounterNum, OutputControl, RecycleMode, TrigType);
this.lblNoteFreqIn.Text =
"NOTE: There must be a TTL frequency at counter 1 input on board "
+ DaqBoard.BoardNum.ToString() + ".";
}
}