private void buttonTestWaveformContinuous_Click(object sender, EventArgs e)
{
// Create a waveform object in PC RAM from waveform file
SD_Wave wave = new SD_Wave("..\\..\\..\\..\\..\\..\\..\\Waveforms\\Triangular.csv");
if (wave.getStatus() < 0)
{
printToConsole("Error opening waveform File");
return;
}
int nWave = 0;
// Switch off angle modulation and Amplitude modulation
moduleAOU.modulationAngleConfig(nChannel, SD_ModulationTypes.AOU_MOD_OFF, 0);
moduleAOU.modulationAmplitudeConfig(nChannel, SD_ModulationTypes.AOU_MOD_OFF, 0);
// Erase all waveforms from module memory and load the waveform waveID in position nWave
moduleAOU.waveformFlush();
moduleAOU.waveformLoad(wave, nWave);
// Config amplitude and setup AWG in nChannel
moduleAOU.channelAmplitude(nChannel, 1.2); // 1.2 Volts Peak
moduleAOU.channelWaveShape(nChannel, SD_Waveshapes.AOU_AWG);
// Flush channel waveform queue
moduleAOU.AWGflush(nChannel);
// Queue waveform nWave in nChannel
moduleAOU.AWGqueueWaveform(nChannel, nWave, SD_TriggerModes.AUTOTRIG, 0, 0, 0); // Cycles = 0
printToConsole("Module configuration successfull. Press CONTINUE to start the AWG");
runPause();
moduleAOU.AWGstart(nChannel);
printToConsole("AWG started. Press CONTINUE to pause the AWG.");
runPause();
moduleAOU.AWGpause(nChannel);
printToConsole("AWG paused. Press CONTINUE to resume the AWG.");
runPause();
moduleAOU.AWGresume(nChannel);
printToConsole("AWG resumed. Press CONTINUE to stop the AWG.");
runPause();
moduleAOU.AWGstop(nChannel);
printToConsole("AWG stopped. Press CONTINUE to start the AWG.");
runPause();
moduleAOU.AWGstart(nChannel);
printToConsole("AWG started. Press CONTINUE to stop the AWG.");
runPause();
moduleAOU.AWGstop(nChannel);
printToConsole("AWG Stopped. Press CONTINUE to finish.");
runPause();
}